Backhaul Analyzer for Anritsu’s RF and Microwave Handheld Instruments : T1/T3 Analyzer (Option 53) 
  
T1/T3 Analyzer (Option 53) 
 
Introduction
Selecting the T1/T3 Analyzer Mode
T1 Fundamentals
Signal Setup
T1 Configuration Menu
Signal Setup
T3 Fundamentals
M13 Framing
C‑bit Framing
Far-End Block Error (FEBE) Function
T3 Display
T3 Configuration Screen
T3 Pattern/Loop Menu
T3 Error/Alarm Menu
T3 Measurement Screen
BERT Histogram Display
Start/Stop Key
T3 Menus
T3 Configuration Menu
Signal Setup
Payload Setup
T3 Pattern/Loop Menu
Payload is 45MB
Payload is less than 45MB
Select Loop Codes Menu
T3 Error/Alarm Menu
Error Ins Menu
Alarm Ins Menu
T3 Measurements Menu
BERT Menu
Histogram Menu
VF Menu
Calibrate Menu
Sweep Menu
Measure Menu
Trace Menu
Limit Menu
Other Menus
T3 In‑service Testing
Required Equipment
Measurement Setup Procedure
Rx Signal Measurement Procedure
T3 Out‑of‑service Measurements
Required Equipment
BERT Measurement Setup Procedure
Basic BERT Measurement Procedure
Quick Check
Histogram Display
To Insert Errors/Alarms
Event List
Rx Signal Measurement Procedure
VF Channel Access Testing
AUTO Signal Setup Explanation
Introduction
This chapter provides a brief description of T3 circuits as well as T3 measurements, and also explains how to measure T3 performance using the instrument with Option 53 installed.
T1/FT1 Analyzer (Option 51 or 54) describe T1 technology and testing, and this chapter describes T3 technology and testing.