2-Port Transmission Measurement Guide : 2-port Transmission Measurement (Option 21)
2-port Transmission Measurement (Option 21)
2-port Transmission Setup
Limit Lines
Calibration Procedure
Save Calibration Setup
Trace Overlay
Bias Tee (Option 10)
Tower Mounted Amplifier Measurement
TMA Configurations
Duplexer Measurement
2-port Transmission Menus
Freq (Frequency) Menu
Span Menu
Standard List Menu
Amplitude Menu
Sweep/Setup Menu
Measure Menu
Trace Menu
Bias Tee Menu
Marker Menu
Marker & Peak Menu
Calibrate Menu
Sweep Menu
Measure Menu
Trace Menu
Limit Menu
Limit Edit Menu
Application Options
Other Menus
The 2-port transmission measurement option provides the capability to perform two-port measurements. This measurement is used to verify the performance of tower-mounted amplifiers, and duplexers, and to verify antenna isolation between two sectors. The excellent dynamic range makes it suitable for repeaters as well.
Both high- and low- power settings are available. The high-power setting delivers approximately 0 dBm power at the RF out port, ideal for antenna isolation measurements and duplexers. When making measurements of a Tower Mounted Amplifier, Anritsu recommends to use the low-power setting (approximately –30 dBm). This will ensure that the RF In port is not over-powered and that the measurements are made in the linear region of the amplifier.
The integrated 32V bias tee (Option 10) enables users to turn on 12 up to 32VDC on the center conductor of the RF In port.