Vector Network Analyzer (VNA) Measurement Guide : VNA Calibration and Measurements
 
VNA Calibration and Measurements
 
Introduction
Setting Frequency Parameters
Entering Start and Stop Frequencies
Entering Center Frequency
Setting the Span
FREQUENCY Menu
Setting Scale Parameters
Setting Resolution and Reference Line
SCALE Menu
SCALE Menu (Smith Chart)
Setting Power Parameters
POWER Menu
POWER CAL
RECEIVER CAL
MEASURE Menu
TIME Menu
DISTANCE Menu
REF PLANE EXT Menu
Setting Sweep Parameters
DATA POINTS
RUN/HOLD
SWEEP TRIGGER
SWEEP TYPE
RF Immunity
SWEEP Menu
SEGMENT SWEEP
TRIGGER SETTINGS
Setting Up Markers
Placing a Normal Marker
Placing a Delta Marker
MARKER Menu
MARKER SEARCH
MARKER FUNCTIONS
MARKER TABLE
Setting Up Limit Lines
Single Limit Lines
Segmented Limit Lines
Limit Table
Limit Alarm
LIMIT Menu (Single)
LIMIT Menu (Segmented)
Calibrations Considerations
Calibration Data and Indications
CALIBRATE Menu
CAL SETUP
TYPE
LINE
CALIBRATION METHODS
MODE
PORT 1 DUT AND PORT 1 CAL KIT
THRU DEVICE
INTERPOLATE
USER CAL
THRU UPDATE
CAL INFO
Setting Trace Parameters
Trace Overlay
Trace Math Example
TRACE Menu
SETUP Menu
DTF AID Menu
Presetting the Analyzer
PRESET Menu
Saving and Recalling Measurements
Saving a Measurement
Recalling a Measurement
FILE Menu
Introduction
This chapter describes some of the VNA measurements that can be made with the Site Master. It includes both 1-port and 2-port measurements (coaxial and waveguide) and features the key considerations that you are required to make regarding calibration types, IF Bandwidth (IFBW), power levels, graph types, and graph formats.